FAQ

1. Remove the protective cap (if used) and place MODIFI3D ORIGINAL on the included stand.
   

2. Plug in the USB (USB 2.0 or 3.0 recommended).
   

3. Touch the metal switch to start heating. A red light indicates that MODIFI3D ORIGINAL is switched on.
   

4. In less than 15 seconds MODIFI3D ORIGINAL will reach around 300ºC (572ºF) and is ready for use. To increase the temperature or reach the maximum of 420-450ºC (788-842ºF) continue to touch the metal switch until the required temperature is reached.
   

5. If MODIFI3D ORIGINAL is not used for 25 seconds it will go into sleep mode (light will go out and the tip will start to cool). To wake MODIFI3D ORIGINAL just gently touch the switch and the heating process will continue.
   

6. Always unplug the USB if MODIFI3D ORIGINAL is not being used.

1. To change tips unplug the USB and allow to cool fully.
   

2. Unscrew the locking nut and pull out the tip
   

3. Push the replacement tip in fully and tighten the locking nut
   

4. Plug in the USB... Easy!

Over time you may want to clean the interchangeable tips. We recommend using a damp sponge to remove any plastic or residue from the tips. This works best whilst the tips are still warm (but obviously not hot enough to pose a risk of burning). Please ensure that the USB is unplugged and the tips have cooled to a safe temperature.

Do not use abrasive cleaning products. This can damage the special coating on the tips.