1)  Select a tip and thread into the single piece heater unit. 2 ) Place Modifi3D PRO2 on the included stand and plug in. 3 ) When the PRO2 is plugged in, it will display  - - -  whilst it detects the power supply voltage. It will then show the voltage detected and automatically match the maximum power of the adapter with the output power of the PRO2. It will then immediately heat up to the last selected temperature. (Note: When using power adapters without PD/QC protocol, the output is limited to 5V, which will lower the heating speed and the maximum temperature to around 200°C).

1) To set the temperature press the  +  or  -  buttons until the desired temperature is selected. 2) After a few seconds the temperature will start to change and the actual temperature will be shown on the digital display. 3) Temperature is adjusted in 1°C/°F increments. To adjust in 10°C/°F increments click and hold the  +  or  -  buttons. 4) A short press of the function button will switch between °C and °F.

Long press the function button for 3 seconds to enter or exit the function menu, then press  +  or  -  to navigate through the menu options.   • The first mode shown on the menu will be the “sleep time” displayed with a flashing  SLP  on the screen. Press the function button to select this mode. Then press  +  or  -  to choose the sleep time and press the function button again to confirm. • To enter the “voltage setting” navigate the menu to the flashing  -U-  option. Press the function button to select this mode. Then press  +  or  -  to choose the input voltage and press the function button again to confirm. • To enter the “temperature unit setting” navigate the menu to the flashing  C-F  option. Press the function button to select this mode. Then press  +  or  -  to choose between ℃ and ℉ and press the function button again to confirm. • To enter the “temperature calibration setting” navigate the menu to the flashing  AdJ  option. Press the function button to select this mode. Then press  +  or  -  adjust. Press the function button again to confirm. Note: This is a calibration mode only. If the tool is working correctly please do not adjust this setting). • To enter the “sleep temperature setting” navigate the menu to the flashing PO option. Press the function button to select this mode. Then press + or - to adjust the sleep temperature between 160℃-320℃. Press the function button again to confirm.

• If Modifi3D PRO2 is still for a selected time, it will go into a standby energy saving mode and the temperature will decline to the pre-selected sleep temperature. Both the time and temperature can be adjusted by setting the  SLP  and  PO  modes in the function menu. • When the PRO2 is moved, it will wake and go into working mode automatically and the temperature will rise to the last selected temperature.

- To change tips unplug from USB-C power and allow the tips to fully cool.  - Unscrew the existing tip from the end of the single piece heater unit (leave the heater unit and locking nut in place), - Replace with your selected tip. - Ensure the heater unit locking nut is tight and plug in the power supply.

- Wipe tips before use to keep in good condition. - Do not keep Modifi3D PRO2 switched on for extended periods of time as this will break down the special coating on the tips. - Do not put excessive pressure on the tip during use to avoid damaging the tip or heater assembly. Let heat do the work. - Never clean tips with coarse, abrasive materials.

1) Unplug from USB-C power and allow to fully cool. 2) Loosen the locking nut and pull out the single piece heater unit. 3) Align with slot in tool and insert new heater. 4) Tighten locking nut

The temperature shown on the LED display is the temperature of the heater element. Due to different tip sizes and shapes heat transfer to the tip edge may vary slightly and hence actual tip temperature may also vary from that shown on the display.